Sundry

Been cleaning and rearranging the shop. Moved this bench left to make room for the compressor but the outlet for the welder has to  move to the other side of the service entrance.  While I am doing that I will tie in the circuit for the lathe.

 

Tuesday, April 17, 2018

Lathe is now wired save for the 15A 2 pole breaker needed.  In the short run it is using a 30A.

Knocked the top bearing out of the cap on the rear of the lathe.   The way I cut the felts they are interfering with the two bearing halves.  Strange I did not catch this.  I know I checked.  I think I checked.  Oh well.